How to use aerial work trucks correctly What steps to pay attention to

As urban construction becomes more and more prosperous, aerial workers are more and more common in life, circuit maintenance, high-rise rescue, staircase cleaning, etc., all need to be completed by professionals at high altitude. Aerial work on the psychological quality of the staff and professional skills have very high requirements, so that aerial work is more convenient, is the original intention of aerial work trucks.

The 22m aerial work truck converted from Dongfeng 4*2 light truck chassis adopts 150hp engine, 2 tons front axle, 4.5 tons rear axle, the whole vehicle weighs 6310kg, and the outer contour dimensions are 6910*2180*3250mm.The rear lifting platform can be operated by using the operation cabin, the operation desk, and the remote control, and the specific operation methods are as follows:

Step 1: Start the vehicle with your foot on the clutch, press the pickup switch, and then slowly release the clutch with your foot.

Step 2: Turn on the platform master switch at the rear of the main driver's side

Step 3: Open the operator compartment behind the passenger side and power on the operator panel.

Step 4: Operate the handle next to the operator panel to adjust the vehicle to level by unfolding all four legs of the platform, and supporting them on the ground.

Step 5: Open the "through the top" of the operation lever, use the operation panel to adjust the state of the telescopic arm, and complete the work.

Step 6: When the operation is finished, reset the telescopic arm, retract the legs, turn off the power switch of the operation panel and platform, and turn off the power take-off.

Precautions:

1. A solid road surface area must be selected for operation.

2. When operating, the handbrake should be pulled up, the vehicle in braking mode and the gear in neutral.

3. When unfolding the outriggers, first extend the outriggers completely, then lower them until they are firmly supported on the ground, (the tires should be suspended, and the force is exerted by the outriggers) level the vehicle with the help of a spirit level. 4.

4. Wear a safety belt when working at height.

5. When the telescopic arm reaches the limiting height, it must not be raised further (the alarm will sound when the limiting height is reached).

6. Try not to put the remote control in the cab when it is not in use, the high temperature from direct sunlight will reduce the service life of the remote control.